Shelf Life | 2 years |
---|---|
Net weight per can | 14 ounces (396 grams) |
Spray pattern | Circular spray applies thin, even film |
Packaging | Aerosol cans or 5 gallon containers |
Drying time | Minimal |
For use on | Metal on metal applications where petroleum products must be avoided, as well as glass, plastics, and rubber |
Lubricant | Pure graphite |
Operating temperature | -100°F – 850°F (-73°C – 454°C) |
Contains chlorinated solvents | Yes |
Contains oil | No |
Conductivity | Conductive |
Corrosion resistance | Yes |
Flammability | Extremely flammable |
NFPA Rating | Level 3 aerosol |
Toxicity | Slight |
Color | Black |
Odor | Solvent odor |
Flash point | -2°F |
Specific gravity | 0.77-0.90 |
pH | N/A |
Vapor density | >1 |
Solubility in water | Partial solubility |
Total VOC% | 48.1% |
Solids content | 3.0% |
Stability | Stable |
Avoid contact with | Strong oxidizing agents |
Storage recommendation | Store in a cool, dry area away from heat or open flame. |
Safety measures | Avoid prolonged or repeated contact with skin or eyes. Apply product in properly ventilated area. |
Application Instructions:
For optimum results, use GS 1100 when the can is between 70°F – 90°F (21°C – 32°C). Shake can for at least one minute after agitator ball shakes free. Continue to shake occasionally during use.
Point sprayhead toward object, holding can 6 – 8 inches (15 – 20cm) away. Press sprayhead firmly. Apply a thin layer and allow product to dry.
If sprayhead clogs, twist ¼ turn or remove and clean by wiping or flushing. Gently twist sprayhead back onto the can opening, holding the top of the can and spray opening away from you. Do not stick a pin or other object into sprayhead slot. Contents are under extreme pressure.
Once treatment is finished, invert the spray can and spray for two seconds until clear. Discard empty can in trash (do not incinerate or compact).