Tech Data
Surface Pro 600
| Container Size | 3.5 Gallons (35 Lbs) |
|---|---|
| Coverage | 4 Sq Ft x 1.22” Depth; approximately 10 lbs. will patch an area 1 sq. ft. x 1' deep (0.08cu ft. when compacted). |
| Application temperature | 0°F to 100°F |
| Cure Time | Open to traffic immediately; allow Surface Pro 600 to cure 30-90 days prior to seal coating |
| Consistency | Free flowing aggregate |
| Pourable | Yes |
| % Residue by Evaporation | >5% |
| Combustible Solvents | Combustible mixture - 140°F+ |
| Flammability | Low |
| Toxicity | Low |
| Flash point | 105°F minimum |
| Boiling range | 300- 390°F |
| Clean-up | Mineral spirits or kerosene |
| Shelf Life | 2 years in unopened containers |
| For use on | Asphalt potholes with/without an asphalt base |
| Color | Black |
| % Volatile by volume | 7.5% |
| Weight/gallon by volume | 14 lbs |
| Stability | Stable |
| Avoid contact with | Heat, flames, strong oxidizers, or carbon oxides |
| Storage recommendations | Store away from heat or open flame |
| Safety measures | Avoid contact with eyes and prolonged or repeated exposure to skin. Do not ingest or inhale. |
Application Instructions:
Surface Preparation
Remove loose and flaking pavement or gravel from area to be filled and redirect traffic until the repair is completed. For best results, square out area to be patched with a #400 asphalt chisel and hammer (available from Superior Industries).
Where no asphalt base is present, lightly spray ST-77 Surface Treatment into area where Surface Pro 600 will be used (NOTE: one aerosol can of ST-77 is included with each unit of Surface Pro 600). Allow ST-77 to cure for approximately 5 minutes.
Scoop Surface Pro 600 from pail and place in hole, filling the hole approximately 25% higher than the surrounding area. Compact aggregate by tamping down with the back of a shovel or using the #71-LD Hand Tamp (also available from Superior Industries). For larger areas, place plywood over filled area and drive over it with vehicle, firmly packing Surface Pro 600. For areas in need of repair deeper than 3 inches, apply patch approximately 2-3 inches thick, compact and repeat in 2-3 inch layers until hole is filled.
Once tamped, Surface Pro 600 is ready for immediate foot and heavy traffic. All patches must be allowed to cure a minimum of 30 days (or up to 90 days depending on weather) prior to application of seal coat.
When repairing large asphalt cracks, pour Surface Pro 600 into cracks and spread with a squeegee to prevent overfilling. Then compact material with a tamp.
Precautions
When transporting this product, ensure that lid is tight and pail secured. Do not allow pail to tumble, as this may cause lid to loosen and leakage to occur.
Where no asphalt base is present, lightly spray ST-77 Surface Treatment into area where Surface Pro 600 will be used (NOTE: one aerosol can of ST-77 is included with each unit of Surface Pro 600). Allow ST-77 to cure for approximately 5 minutes.
Do not transport on passenger seats or inside the passenger compartment of any vehicle. Store product in the cargo area of vehicle, and secure over protective cloths to prevent damage due to accidental spills.
CLOSE CONTAINER WHEN NOT IN USE. Do not reuse empty container. Dispose of container in an environmentally acceptable manner.