Thursday, May 30, 2024
Your shopping cart is empty.

"We Ship Worldwide"

Have A Question?...
Call Us Toll Free 800-476-2072
Click Here to Buy Now

Tech Data

Crete Repair UWP



3 gallon or 15 gallon kit
Tan/light brown (when mixed)
Mix Ratio
2 parts A to 1 part B by volume
Shelf Life
1 year in unopened containers
Pot Life
20-30 minutes at 70° F
Dry to Touch
3-12 hours at 70° F
Cure Time for Recoat or Topcoat

3-12 hours at 70° F

Cure Time for Light Foot Traffic
10-24 hours at 70° F
Full Cure
2-7 days
Recommended Film Thickness

1/8” cracks or thin build repairs

0.13 ft3 or 1,228 lineal ft at 1/8” x 1/8”

None necessary

Application Temperature
35-90° F
Solids by Weight


Solids by Volume 100%
Volatile Organic Content
Zero pounds/gallon
Flexural Strength 4,910 psi @ ASTM D790
Compressive Strength 9,400 psi @ ASTM D695

405 psi (dry), 305 psi (wet) @ elcometer (concrete failure, no delamination)


Mixed= 2,500,000- 3,000,000 cps (typical)

Tensile Strength 4,102 psi @ ASTM D638
Ultimate Elongation 2.3%
Hardness Shore D = 65
Heat Deflection Temperature 59 degrees C (138 degrees F)
DOT Classifications Part A- not regulated; Part B- Corrosive liquid N.O.S., 8, UNI1760, PGIII
Gardner Variable Impactor 50 inch pounds direct- passed

Application Instructions

  1. Product Storage: Store product at normal room temperature before using. Continuous storage should be between 60 and 900 F. Low temperatures or temperature fluctuations may cause crystallization.
  2. Surface Preparation: All new concrete must be cured for at least 30 days prior to application. All dirt, foreign contaminants, oil contamination and laitance must be removed to assure a trouble free bond to the substrate. This product is intended for hairline cracks and other fractures up to an 1/8 inch in width. Remove all unsound concrete from within the crack to be repaired and thoroughly remove all debris from within the crack opening.
  3. Product Mixing: This product has a mix ratio of 2 parts A to 1 part B by volume. To mix, simply measure out equal volumes of the material and mix them together thoroughly with slow speed mixing equipment such as a jiffy mixer, putty knife or spatula until the material is thoroughly mixed and uniform in color. Mix only an amount of material that can be used in the allotted pot life period. Improper mixing may result in product failure.
  4. Product Application: No priming is necessary. The material can be applied by marginal trowel, putty knife or any other suitable equipment. It is important to thoroughly work the paste into the repair area so as to displace any water from within the repair area. This product can be used underwater as well as in any area where the flow of water cannot be controlled. Restrict the use of the floor to light traffic and non-harsh chemicals until the coating is fully cured. It is best to let the floor remain dry for the full cure cycle.
  5. Recoat or Topcoating: For underwater repairs, we do not recommend any topcoat be applied. Allow Crete Repair UWP to become tack free prior to topcoating. Multiple coats of Crete Repair UWP are acceptable and bond readily. Use xylol for post-application cleanup.