Diamond Grip
Tech Data
| Curing Time | Foot Traffic-8 To 10 Hours - Heavy Traffic-18 to 24 Hours |
|---|---|
| Coefficient of Friction | Greater Than 1.57 |
| Color | Charcoal |
| Appearance | Heavily Textured Non Slip Surface |
| Application Temperature | 50° F to 90° F |
| Method of Application | 3/8” Dynel Type Paint Roller |
| Approved Surface Applications | Steel, Wood, Aluminum, Brick, Block, Fiberglass |
| Odor | Slight |
| Expected Service Life | 5 To 7 Years |
| Shelf Life | 2 Years in Unopened Containers |
| Non Slip Aggregate Hardness | Mohs Hardness @20°C : 9.1-9.5 |
| Kit Sizes | 20, 100, & 200 Square Feet Custom Kits Available, Call Technical Service 800.476.2072 |
Diamond Grip is a 100% solids epoxy and is applied using a 3/8" nap, paint type roller. The epoxy consists of two parts, (a) Resin , (b) Catalyst. The catalyst is poured into the resin and mixed thoroughly for approximately 2 to 3 minutes. The pot life of mixed material is approximately 15 minutes and should be emptied from can as quickly as possible and spread evenly. The aggregate (included), is then broadcast into wet substance to the point of rejection. After approximately 8 to 10 hours, sweep away excess aggregate.
Diamond Grip adheres to: Aluminum • Brick • Cinder Block • Concrete • Steel • Wood
Note: Diamond Grip is effective on many other surfaces; . Consult our Technical Department for your application.
Cure Times: 8 to 10 hours for foot traffic • 12 to 24 hours for Heavy traffic such as forklifts
Preparation:
Note: The following procedures should be followed without exception
Aluminum
- Clean surface thoroughly using a water soluble degreaser
- Rinse and allow to dry thoroughly
- Abrade surface with a 60 grit sanding disc or acid etch with an inhibited hydrochloric acid solution. Our "CRX" is the recommended choice.
- Allow to dry thoroughly before applying Diamond Grip.
Brick
- Clean surface thoroughly using a water soluble degreaser
- Rinse and allow to dry overnight before applying Diamond Grip (Brick should be installed in a suitable base not subject to Hydrostatic Pressure. (underside moisture)
Cinder Block (See Brick Prep)
Concrete
- Clean surface thoroughly using a water soluble degreaser
- Rinse and allow to dry
- Abrade surface with a 60 grit sanding disc or acid etch with an inhibited hydrochloric acid solution. Our "CRX" is the recommended choice
- Thoroughly rinse and allow to dry overnight before applying Diamond Grip. Note: Use a rotary floor machine with steel brushes for cleaning when possible.
Steel (See Aluminum Prep)
Wood
- Clean surface thoroughly using a water soluble degreaser
- Rinse and allow to dry overnight or until wood is completely dry before applying "Diamond Grip".
NOTE: Do Not Apply "Diamond Grip" to green or uncured wood surfaces